BISSELL Proheat 2X Revolution

Product Care

• Refer to the User Guide & Safety Instructions Included
• Maintenance: Cleaning Machine After Use: Unplug from electrical socket when not in use and before cleaning, maintaining or servicing the appliance. First, fill the clean water tank with warm tap water and then empty it all to rinse. Then fill again with warm tap water and return the tank to the machine. Twist cap back on tightly. To flush and rinse machine: Turn the machine on and press the spray trigger for 15 seconds while making back and forth passes on a section of carpet. Release the spray trigger and suck up the water. See page 11 to clean the water that was just sucked up from the dirty tank. Empty the clean water tank and let dry before storing. Wipe your machine’s exterior with a soft cloth.
• Maintenance: Cleaning the Nozzle: If pet hair or debris become clogged in the nozzle, it can be cleaned out of the nozzle with the nozzle clean out tool. Turn off and unplug the machine from the grounded outlet. Remove the nozzle from the foot: flip the accessory hose door open and lift up on the nozzle and accessory hose door. Hold the nozzle and insert the nozzle clean out tool into the thin slot, on the end of the nozzle that touches the floor. Clean until free of pet hair or debris. Return the nozzle back to the foot of the machine. Line up the three hooks on the nozzle to the bottom of the foot. (see arrows for location) Rotate the nozzle up and click into place. Close the accessory hose door.
• Maintenance: Cleaning the Brush Rolls: Turn off and unplug the machine from the grounded outlet. Lay the machine down on its back or side. Use the comb to brush out the debris or hair from the brush rolls.
• Maintenance: Replacing Belt or Brush Rolls: You will need: 1 Phillips screwdriver & 1 flathead screwdriver. Unplug the machine. Remove both tanks from the machine. Press the recline pedal and lay the machine on its back. Use a flathead screwdriver to help lift and remove the Belt Access Door. Here you should see one (1) belt. This is the Flat Pump Belt. If the Flat Pump Belt is broken, gently remove it from the machine. We will replace this belt in Step 5. Turn the machine on its side. The Power Button should be facing up. Remove the 3 screws on the Belt/Brush Access Plate using a Philips screwdriver. Remove the Access Plate to expose the Brush Cover and Cogged Large Pump Belt. Remove the Brush Cover by lifting straight up. Remove the Cogged Large Pump Belt. The brush rolls can be replaced or cleaned at this time, if needed. Now, if the Flat Pump Belt was broken, place a new Flat Pump Belt around the red area of the large pulley. Then use your thumb to stretch it toward the back of the machine and transfer it onto the metal axle.
• Storing Your Machine Once your cleaning is complete, make sure both the dirty and clean water tanks are emptied, rinsed out, and dried before the next use. Wrap cord around cord wrap for storage. Store machine in a protected, dry area.