BISSELL PowerEdge Cordless Vacuum

Product Care

• Refer to the User Guide & Safety Instructions included
• Emptying the Dirt Tank:
  • 1. Turn OFF your machine. Remove the Dirt tank from the hand vacuum by pressing the tank release button on the front of the tank.
  • 2. Grab the middle grip of the filter and pull up. This will activate a wiping feature to remove debris from the mesh filter screen. Twisting the grip will remove the filter only.
  • 3. Fully remove the separator from the tank and tap the mesh screen on the side of the trash bin.
  • 4. Dump dirt from the tank into the trash bin.
  • 5. Slide the separator back into the tank, ensuring the notch is seated into the tank correctly.
  • 6. Reattach tank by guiding the bottom into the hook on the hand vacuum. Push into place.
• Cleaning & Replacing the Filters Pre-Motor Filter
  • 1. For best cleaning performance, always clean your filter after each use. Turn machine OFF. Remove dirt tank by pressing the tank release button and sliding the tank out.
  • 2. Twist top to remove filter frame from the separator. Remove the filter from the filter frame housing. Tap the filter against the side of a trash bin to remove dust and debris.
  • 3. Rinse under warm water and squeeze to remove dirt. Lay out for 24 hours until completely dry. Reinsert filter into the frame with the tag side touching the frame.
• Cleaning & Replacing the Filters Post-Motor Filter
  • 1. To clean the post-motor filter located on the back of the hand vac, turn OFF machine. Pinch the latch on the filter cover to remove.
  • 2. Press up on the bottom tab to pull filter out.
  • 3. If there’s debris on the filter, tap it on a trash bin and rinse under warm water. Let dry for at least 24 hours before putting it back in the vacuum and replacing the filter cover.
• Maintaining and replacing your vacuum.
  • 1. Turn the machine OFF and press the foot release button to disconnect the motorized cleaning foot.
  • 2. Use a flathead screwdriver or coin to twist the bottom screws counter-clockwise and release the brush roll side covers.
  • 3. After turning the screws counter-clockwise pull the brush roll cover toward you and remove it from the floor nozzle.
  • 4. Remove the brush roll. Push the end of the brush dowel to the left and lift the brush roll out of the foot.
  • 5. After brush roll is removed clear any debris from the brush, brush housing, and air suction channel.
  • 6. After clearing debris, place the brush roll cover back onto the floor nozzle.
  • 7. Attach and secure brush roll cover by using flathead screwdriver or coin to twist the screws clockwise.
  • 8. Remove debris from brushes and rinse under warm water. Let dry for 24 hours.