BISSELL Omnipet Icon Turbo

Product Care

• Refer to the User Guide & Safety Instructions included
• Emptying the Dirt Tank:
  • 1. Turn OFF your machine. Remove the dirt tank by sliding the latch on the front. 4. Dump dirt from the tank into the trash bin.
  • 2. Grab the top of the tank and pull up. This will activate a wiping feature to remove debris from the mesh filter screen.
  • 3. Remove the separator from the tank and tap on the side of the trash bin. Slide the separator back into the tank, ensuring the notch is seated into the tank correctly.
• Removing the Brush Roll:
  • 1. Turn the machine OFF and press the foot release button to disconnect the foot from the extension wand.
  • 2. With a flathead screwdriver or coin, twist the slot on the side of the foot clockwise and pull the brush roll out.
• Cleaning & Replacing the Filters: Pre-Motor Filters: For best cleaning performance, always clean your pre-motor filter after each use.
  • 1. Turn OFF machine and remove dirt tank from the hand vacuum.
  • 2. Pull filter from the top of the tank. Remove the filter from the filter frame housing. Tap the filter against the side of a trash bin to remove dust and debris.
  • 3. Rinse under warm water and squeeze to remove dirt. Lay out for 24 hours, until completely dry. Replace filter into the frame with the tag side down (touching the frame) before use.
• Cleaning & Replacing the Filters Post-Motor Filter
  • 1. Turn OFF machine and press the latch on the back of the hand vacuum.
  • 2. Remove the post-motor filter from the vacuum.
  • 3. If there’s debris on the filter, tap it on a trash bin and rinse under warm water. Let dry for at least 24 hours before putting it back in the vacuum and replacing the filter cover.